Safety
TF 50 E | Version 1.05 5
2.3 Qualification of personnel
The different tasks described in this manual represent
different requirements to the qualification of the persons
entrusted with these tasks.
Only persons reliable working procedures can be
expected from, are allowed to perform all works. Persons
the responsiveness of which is affected by e. g. drugs,
alcohol or medication, are not allowed to work with the
machine.
The qualifications of the personnel for the different tasks
are mentioned below:
Operator:
The operator is instructed by the operating company
about the assigned tasks and possible risks in case of
improper behaviour. Any tasks which need to be
performed beyond the operation in the standard mode
must only be performed by the operator if it is indicated
in these instructions and if the operating company
expressively commissioned the operator.
Electrical specialist:
With professional training, knowledge and experience as
well as knowledge of respective standards and
regulations, qualified electricians are able to perform
work on the electrical system and recognise and avoid
any possible dangers.
Qualified personnel:
Due to their professional training, knowledge and
experience as well as their knowledge of relevant
regulations the specialist staff is able to perform the
assigned tasks and to recognise and avoid any possible
dangers themselves.
Manufacturer:
Certain works may only be performed by specialist
personnel of the manufacturer. Other personnel is not
authorized to perform these works. Please contact our
customer service for the execution of all arising work.
2.4 Personal protective equipment
The personal protective equipment serves to protect
persons against impairments of safety and health while
working. The staff member has to wear personal
protective equipment while performing different tasks on
and with the machine which are indicated in the
individual paragraphs of these instructions. The personal
protective equipment is explained in the following
paragraph:
WARNING!
Danger in case of insufficient
qualification of the staff!
Insufficiently qualified personnel are not capable of
assessing the risks associated with machine use and
may expose themselves and others to the risk of
severe or fatal injuries.
- Have all works only performed by qualified persons.
- Keep insufficiently qualified persons out of the work-
ing area.
Head protection
The industrial helmet protects the head against
falling objects and hitting on fixed objects.
Ear protection
The hearing protection protects against damages of
hearing due to noise.
Safety goggles
The safety goggles are used to protect the eyes from
flying parts.
Protective gloves
The protective gloves serve to protect the hands
against sharp components as well as against friction,
abrasions or deep injuries.
Safety boots
Safety boots protect the feet against crushing, falling
parts and slipping over on slippery ground.
Protective work clothing
Protective work clothing is close-fitting work clothing,
without protruding parts, with low tear resistance.
To Next Page
Loading...