Honda 2005 CRF250X - Page 144

COOLING SYSTEM
6- 14
Install the wate r pump shaft into the right crankcase
cover.
Install the plain washer and impe ller onto the water
pump shaft .
• The impeller ha s left hand threads.
Tighten the
impeller to the specified torque.
TORQUE: 12 N'm (1 .2 kgf·m, 9 I bf.f t)
Install the right crankcase cover (page 10-6).
Install a new O-ring onto water pump cover.
Install the dowel pin.
Install the water pump cover and tighten the bolts.
Tighten the
drain bolt with new sealing washer .
Connect the water hose and tighten the band screw.
Fill the system with the recommended coolant and
bleed
the air (page 6-7).
PLAIN WASHERS
WATER PUMP SHAFT
RIGHT CRANKCASE COVER
IMPELLER
I