Honda 2005 CRF250X - Clutch Switch Inspection

CLUTCH SWITCH
INSPECTION
Remove the front visor (page 2-5).
Disconnect the engine stop button 3P connector and
clutch switch wire connector.
Check for continuity between the Black/Brown ter-
minal and Black/red wire connector.
There should be continuity with the clutch lever
squeezed, and no continuity with the clutch lever
released.
If the continuity is abnormal, remove the clutch
switch (page 19-7).
Remove the clutch lever bracket (page 13-31),
Remove the boot.
Remove the screw, stay and clutch switch.
Disconnect the connectors.
Check for continuity between the clutch switch ter-
minals.
There should be continuity with the switch applied,
and there should be no continuity with the switch is
released.
If the continuity at the connectors is abnormal and
the continuity at the clutch switch terminal is nor-
mal, check the connectors for loose connection and
the wire harness for an open circuit or loose conec-
tion.
LIGHTS/METER/SWITCHES
CLUTCH SWITCH
BRACKET
SCREW
BOOT
CLUTCH SWITCH
19-7