FRAME/BODY PANELS/EXHAUST SYSTEM
The left fender stay
has
the
"11'
mark
at
the upper
end.
LEFT INNER FENDER
Remove the following:
-
three bolts
-
left fender stay
-
two trim clips
-
two tapping bolts
Unhook the two slots in the fender from the tabs.
Release the retaining tab from the frame, unhook
the rubber seal from the tab and remove the left
inner fender.
Install the left inner fender in the reverse order of
removal.
LEFT INNER FENDER
TAPPING BOLTS
/
SLOTS
MARK
TRIM CLIPS
BOLTS
FRONT CARRIER/CARRY PIPE
FRONT CARRIER
Remove the following:
Be
careful
not to - two 6 mm bolts and collars
scratch
the front - four 8 mm bolts
fender.
- front carrier
Install the front carrier in the reverse order of
removal.
TORQUE: 8 mm bolt: 37 Nm (3.8 kgf-m, 27 Ibf-ft)
FRONT CARRIER
8
mm
BOLTS
COLLARS
6
mm
BOLTS
FRONT CARRY PIPE
CARRY PIPE GUARD/FRONT SKID PLATE
Remove the following:
Carry pipe guard:
-
four trim clips
-
two 6 mm bolts
-
carry pipe guard
Front skid plate:
-
four 8 mm bolts
-
front skid plate
Install the carry pipe guard and front skid plate in
the reverse order of removal.
CARRY PIPE GUARD
TRIM CLIPS
8 mm BOLTS
6 mm BOLTS
FRONT SKID PLATE
3-8
To Next Page
Loading...
Need help?
General
