INSTALLATION
OUTBOARD MOTOR ATTACHMENT
Attach the stern bracket to the tran-
som and tighten the clamp screws.
l
Before operating the boat, check
the tightness of the clamp screws.
l
Tie a rope through the hole in the
stern bracket and secure the other
end of the rope to the boat. This
will prevent accidental loss of the
motor.
MOTOR ANGLE FOR CRUISING
Adjust the motor so the propeller
shaft is parallel with the water sur-
face.
INCORRECT INCORRECT CORRECT
CAUSES BOAT TO
CAUSES BOAT TO
GIVES MAXIMUM PERFORMANCE
“SQUAT”
“PLOW”
20
To Next Page
Loading...
