Honda SH300 2008 User Manual

HYDRAULIC BRAKE
17-6
TROUBLESHOOTING
Brake lever soft or spongy
• Air in hydraulic system
• Leaking hydraulic system
• Contaminated brake pad/disc
• Worn caliper piston seal
• Worn master cylinder piston cups
• Worn brake pad/disc
• Contaminated caliper
• Contaminated master cylinder
• Caliper not sliding properly
• Low brake fluid level
• Clogged fluid passage
• Warped/deformed brake disc
• Sticking/worn caliper piston
• Sticking/worn master cylinder piston
• Bent brake lever
Brake lever hard
• Clogged/restricted hydraulic system
• Sticking/worn caliper piston
• Caliper not sliding properly
• Worn caliper piston seal
• Sticking/worn master cylinder piston
• Bent brake lever
Brake drags
• Contaminated brake pad/disc
• Misaligned wheel
• Badly worn brake pad/disc
• Warped/deformed brake disc
• Caliper not sliding properly
• Clogged/restricted brake hydraulic system
• Clogged/restricted fluid passage
• Clogged master cylinder port
• Sticking caliper piston

Honda SH300 2008 Specifications

General

Displacement	279 cc
Bore x Stroke	72 mm x 68.5 mm
Compression Ratio	10.5:1
Fuel System	PGM-FI electronic fuel injection
Ignition	Digital transistorized with electronic advance
Front Suspension	Telescopic fork
Front Tire	110/70-16
Rear Tire	130/70-16
Engine Type	Liquid-cooled, 4-stroke, single-cylinder
Max Torque	26.5Nm / 6, 000rpm
Transmission	V-Matic
Rear Suspension	Dual shocks
Front Brake	Single 256 mm disc
Rear Brake	240mm hydraulic disc