Honda SH300 2008 User Manual

MAINTENANCE
4-20
Inspect the brake hose and fittings for deterioration,
cracks, damage or signs of leakage.
Tighten any loose fittings.
Replace hose and fittings as required.
COMBINED BRAKE SYSTEM INSPEC-
TION
This model is equipped with a Combined Brake Sys-
tem.
Check the rear brake operation as follows:
Place the scooter on its centerstand.
Jack up the scooter to raise the front wheel off the
ground.
Apply the rear brake lever.
Make sure that the front wheel does not turn while
the rear brake lever is applied.
HEADLIGHT AIM
Support the scooter upright on a level surface.
Adjust the headlight beam vertically by turning the
adjusting screw.
BRAKE HOSES
REAR BRAKE LEVER
FRONT WHEEL
Adjust the headlight
beam as specified
by local laws and
regulations.
ADJUSTING SCREW

Honda SH300 2008 Specifications

General

Displacement	279 cc
Bore x Stroke	72 mm x 68.5 mm
Compression Ratio	10.5:1
Fuel System	PGM-FI electronic fuel injection
Ignition	Digital transistorized with electronic advance
Front Suspension	Telescopic fork
Front Tire	110/70-16
Rear Tire	130/70-16
Engine Type	Liquid-cooled, 4-stroke, single-cylinder
Max Torque	26.5Nm / 6, 000rpm
Transmission	V-Matic
Rear Suspension	Dual shocks
Front Brake	Single 256 mm disc
Rear Brake	240mm hydraulic disc