Honeywell Home T6 Pro Smart User Manual

22
When the thermostat is in idle mode, you can
adjust how bright you’d like the screen. You
can choose a brightness level from 00 (display
backlight is off, which is the default) up to 05
(maximum brightness). To adjust backlight
brightness, follow the steps below.
1 Touch Menu on the thermostat home screen.
2 Touch the or arrows until you see
BRIGHTNESS, then touch Select.
3 Touch
or to adjust the brightness level,
which will change immediately.
4 Touch Done to confirm.
Adjusting backlight brightness
Over time, your T6 Pro Smart thermostat will
learn how long it takes your system to reach the
desired temperature. It can then turn on your
heating or cooling equipment at the right time to
make sure your home is comfortable by the time
you expect. This feature is enabled by default. To
disable it, follow the steps below.
1 Touch Menu on the thermostat home screen.
2 Touch the
or arrows until you see
RECOVERY, then touch Select.
3 Touch the or arrows to select
RECOVERY ON or RECOVERY OFF, then
touch Done to confirm.
When Adaptive Intelligent Recovery is active,
you’ll see the recovery symbol in the upper-right
corner of the thermostat screen.
Enabling/disabling Adaptive Intelligent Recovery
AM
Menu FanMode
Fan
Auto
Mode
Heat
Wake AwayHomeSleep
Following Schedule
Recovery
Back Select
Back Select
Done Cancel
AM
Menu FanMode
Fan
Auto
Mode
Heat
Wake AwayHomeSleep
Following Schedule
Recovery
Done
Cancel
Recovery

Honeywell Home T6 Pro Smart Specifications

General

Brand	Honeywell Home
Model	T6 Pro Smart
Category	Thermostat
Language	English