Honeywell 4600g - Page 103

7 - 9
When Check Digit is set to Validate, but Don’t Transmit, the unit only reads
Interleaved 2 of 5 barcodes printed with a check digit, but will not transmit the
check digit with the scanned data.
When Check Digit is set to Validate and Transmit, the imager only reads Inter-
leaved 2 of 5 barcodes printed with a check digit, and will transmit this digit at
the end of the scanned data.
Default = No Check Digit.
Interleaved 2 of 5 Message Length
Scan the barcodes below to change the message length. Refer to Message
Length Description (page 7-2) for additional information. Minimum and
Maximum lengths = 2-80. Minimum Default = 4, Maximum Default = 80.
Validate, but Don’t Transmit
* No Check Digit
Validate and Transmit
Minimum Message Length
Maximum Message Length