Honeywell 4600g - Image Snap and Ship

3 - 8
Image Snap and Ship
Image Snap and Ship tells the imager to take a picture (rather than read a bar-
code) the next time the trigger is pressed. Once the picture is snapped, it is
shipped to the host system as a jpeg file. The imager then reverts to barcode
reading for the next trigger press.
Hands Free Time-Out
The Scan Stand, and Presentation, and Streaming Presentation Modes are
referred to as “hands free” modes. If the imager’s trigger is pulled when using a
hands free mode, the imager changes to manual trigger mode. You can set the
time the imager should remain in manual trigger mode by setting the Hands
Free Time-Out. Once the time-out value is reached, (if there have been no fur-
ther trigger pulls) the imager reverts to the original hands free mode.
Scan the
Hands Free Time-Out barcode, then scan the time-out duration (from
0-300,000 milliseconds) from the inside back cover, and
Save . Default = 5,000
ms.
Reread Delay
This sets the time period before the imager can read the same barcode a sec-
ond time. Setting a reread delay protects against accidental rereads of the
same barcode. Longer delays are effective in minimizing accidental rereads.
Use shorter delays in applications where repetitive barcode scanning is
required.
Default = Medium.
Image Snap and Ship
Hands Free Time-Out