Honeywell 4600g - Working Orientation

3 - 22
Video Reverse is used to allow the imager to read barcodes that are inverted.
The “Off” barcode below is an example of this type of barcode. If additional
menuing is required, Video Reverse must be disabled to read the menu bar-
codes and then re-enabled after menuing is completed.
Note: Images downloaded from the unit will not be reversed. This is a setting
for decoding only.
Working Orientation
Some barcodes are direction-sensitive. For example, KIX codes and OCR can
misread when scanned sideways or upside down. Use the working orientation
settings if your direction-sensitive codes will not usually be presented upright to
the imager.
Default = Upright.
On
* Off
Upright:
Rotate Code Clockwise 90°:
Upside Down:
Rotate Code
Counterclockwise 90°: