7 - 45
QR Code
< Default All QR Code Settings >
QR Code
This selection applies to both QR Code and Micro QR Code.
Note: The default applies to firmware with a base number of 31205480. Refer
to the Show Software Revision on page 11-2 for information on
determining the firmware revision in your unit
QR Code Message Length
Scan the barcodes below to change the message length. Refer to Message
Length Description (page 7-2) for additional information. Minimum and
Maximum lengths = 1-3500. Minimum Default = 1, Maximum Default = 3500.
To Next Page
Loading...
