Honeywell 4600g - Code 39

7 - 5
Codabar Message Length
Scan the barcodes below to change the message length. Refer to Message
Length Description (page 7-2) for additional information. Minimum and
Maximum lengths = 2-60. Minimum Default = 4, Maximum Default = 60.
Code 39
< Default All Code 39 Settings >
Code 39
Code 39 Start/Stop Characters
Start/Stop characters identify the leading and trailing ends of the barcode. You
may either transmit, or not transmit Start/Stop characters.
Default = Don’t
Transmit.
Code 39 Check Character
No Check Character indicates that the imager reads and transmits barcode
data with or without a check character.
Minimum Message Length
Maximum Message Length
* On
Off
Transmit
* Don’t Transmit