Honeywell 4600g - Wand Emulation Connection

To Next Page

To Previous Page

1 - 13

Each of the previous barcodes also programs the following suffixes for each

symbology:

The IBM 4683 Port 9B HHBCR-2 Interface barcode also programs the following

suffixes for each symbology:

Wand Emulation Connection

Note: See "Imager Models" on page 1-2 to determine which interfaces apply to

your imager.

In Wand Emulation mode, the imager decodes the barcode then sends data in

the same format as a wand imager. The Code 39 Format converts all symbolo-

gies to Code 39.

The Same Code Format transmits UPC, EAN, Code 128, Codabar, and Inter-

leaved 2 of 5 without any changes, but converts all other symbologies to Code

39. 2D symbologies are converted to Code 128.

The

Wand Emulation Plug & Play (Code 39 Format)

barcode below sets the

terminal ID to 61. The

Wand Emulation Plug & Play Same Code

barcode

sets the terminal ID to 64. These barcodes also set the Transmission Rate to

Symbology

Suffix

EAN-8 0C

EAN-13 16

UPC-A 0D

UPC-E 0A

Code 39 00 0A 0B

Interleaved 2 of 5 00 0D 0B

Code 128 00 0A 0B