Honeywell 4600g - Serial Wedge Data Transmission Port; IBM 4683 Ports 5 B, 9 B, and 17 Connection

1 - 12
Serial Wedge Data Transmission Port
Using the following barcodes, set the port to which you want the scanned data
to transmit. Port 1 corresponds to P1 on the output cable and Port 2 corre-
sponds to P2 on the output cable. Choosing Both sends scanned data to P1
and P2.
Default = P1.
IBM 4683 Ports 5B, 9B, and 17 Connection
Note: See "Imager Models" on page 1-2 to determine which interfaces apply to
your imager.
Scan one of the following “Plug and Play” codes to program the imager for IBM
4683 Port 5B, 9B, or 17.
Note: After scanning one of these codes, you must power cycle the cash
register.
* P1
P2
Both P1 and P2
IBM 4683 Port 5B Interface
IBM 4683 Port 9B
HHBCR-1 Interface
IBM 4683 Port 17 Interface