Honeywell 4600g - Page 8

ii
Wand Emulation ........................................................2-13
Data Block Size ...................................................2-13
Delay Between Blocks .........................................2-14
Overall Checksum ...............................................2-14
Wand Emulation Transmission Rate ...................2-15
Wand Emulation Polarity .....................................2-15
Wand Emulation Idle............................................2-16
Chapter 3 - Output
Good Read Indicators..................................................3-1
Beeper – Good Read.............................................3-1
Beeper Volume – Good Read................................3-1
Beeper Pitch – Good Read....................................3-2
Beeper Duration – Good Read ..............................3-2
LED – Good Read .................................................3-2
Number of Beeps – Good Read ............................3-2
Good Read Delay ........................................................3-3
User-Specified Good Read Delay................................3-3
Trigger Modes..............................................................3-4
Manual/Serial Trigger ............................................3-4
In-Stand Sensor Mode (4600r only).............................3-5
Scan Stand Mode ........................................................3-5
Scan Stand Symbol ...............................................3-6
Presentation Mode.......................................................3-6
Presentation LED Behavior after Decode..............3-7
Presentation Sensitivity .........................................3-7
Streaming Presentation™ Mode..................................3-7
Image Snap and Ship ..................................................3-8
Hands Free Time-Out..................................................3-8
Reread Delay...............................................................3-8
User-Specified Reread Delay ......................................3-9
LED Power Level.........................................................3-9
Illumination Lights......................................................3-10
Imager Time-Out........................................................3-11
Aimer Delay ...............................................................3-11
User-Specified Aimer Delay.................................3-11