To Next PageTo Next Page
Need help?Do you have a question about the Honeywell 7000 and is the answer not in the manual?
General| Brand | Honeywell |
|---|---|
| Model | 7000 |
| Category | Security System |
| Language | English |
The Honeywell 7000 is a solid state fire/burglary and home health care alarm system designed to protect a wide range of private residences.
Details system power requirements, including AC input and low voltage input to the control panel.
Specifies the current ratings for system outputs such as Bell/Horn and Auxiliary power.
Provides information on wiring for fire and burglary circuits, including maximum lengths and wire gauges.
Outlines the system's operating environmental conditions and physical dimensions.
Contact information for local sales office and customer relations for product inquiries.
Provides a general overview of the system and lists equipment for installation and hookup.
Details the main functions of the control panel and its internal components.
Specifies ideal locations for the control panel, considering environmental factors and accessibility.
Instructions for mounting the control panel enclosure on drywall or plywood.
Guide for installing the circuit board and connecting various system components.
Instructions for installing the PEM, which adds hardwire points to the system.
Details PEM wiring connections and address configuration for up to 11 PEMs.
Guide for mounting the RFEM which provides additional RF protection points.
Instructions for connecting the RFEM and installing the RF Receiver for wireless sensor communication.
Details RF receiver wiring and switch configuration for address settings.
Instructions for installing keypads and connecting them via the HBus.
Explains the use of input loops for zoning sensors and identifying protection points.
Details requirements for wiring burglary detection circuits, including EOL resistors.
Covers supported two-wire fire detectors and installation requirements.
Details the system's support for two-wire smoke detectors on Loop 8.
Instructions for installing two-wire smoke detectors on Loop 8.
Details four-wire smoke detector supervision and approved devices.
Instructions for installing four-wire smoke detectors and operating the reset relay.
Guide for programming and integrating Series 5800 RF sensors with the system.
Details wiring for control panel and PEM programmable outputs and relays.
Instructions for installing external sounding devices like bells and horns.
Steps for installing the 120 Vac to 24 Vac plug-in transformer.
Guide for installing rechargeable batteries for system standby power.
Explains the formula used to calculate battery capacity based on system current draw.
Steps to prepare the system for local or remote programming via PC.
Procedure for powering up the system and initial setup after programming.
Checklist for entering customer-specific data and system programming options.
Explains how to use the keypad, including display messages and button functions.
Details how the keypad provides help and how to manage system modes.
Procedures for emergency shutdown and operation during power outages.
Procedure for testing the system installation after setup is complete.
Steps for performing local tests to verify system functionality.
Procedure for testing communication with the CSC.
Tests for duress code functionality and local telephone line connections.
Key requirements for UL compliance in system installation.
Specific requirements mandated by the California State Fire Marshal.
FCC statements regarding equipment operation and interference.
