Accenta/Optima Engineer’s Manual
18
Menu Options
The full menu structure for the panel can only be accessed while in Engineer program mode. The structure is
shown in the following table:
Table 2. Menu Options
Menu Options
Enter Engineer program mode. Press [9] [9] [9] [9].
0 = Walk Test
The walk test function allows each detector to be checked in order to verify that they are functioning correctly.
A tone is generated as each zone is activated (opened).
LED keypad
• Press [0] for menu Walk Test.
• Press . Zones 1-8 are off
• When a zone is sucsessfully tested, the LED is on.
Zones are added to list as eachone is activated.
• The Tamper LED comes on when tested.
• Press to leave the menu or to restart
the Walk Test.
LCD keypad
• Press for menu Walk Test.
• Press or [0]. Zones 1-8 have a zero (0)below
each number.
• When a zone is sucsessfully tested, number 1replaces the 0.
Zones are added to list as eachone is activated.
• Press to leave the menu or to restart the Walk Test.
MENU OPTIONS
0 = Walk Test 6 = Zone Names
1 = Alarm Test 7 = Timers
2 = Test Outputs 8 = Codes
3 = System Flags C = View Event Log
4 = Time and Date O = Omit Allow & Double
Knock
5 = Language P = Programmes
To Next Page
Loading...
Need help?
General
