46 Installation instructions / ACS-2 plus
This will open the ACS-2 plus setup:
******************************************************************************
** SETUP - ACS-2 plus **
******************************************************************************
Setup from: APPL. Login.
Label: [<no-name...>]
1. Communication
2. System
3. Save
4. Exit
No.:_
Meanings:
Setup from: Shows the mode via which the setup was called.
APPL.-Login = Application login
The setup was called during current operation of the ACS-2 plus.
BOOT-Login
The setup was called during the booting process of the ACS-2 plus.
The entry of cea [Enter] must be given within 3 seconds
during the booting process of the ACS-2 plus. During this
time the LED 1 (located on the CPU board on the left-hand
side of the heat sink, see 14.1) lights up green.
If cea [Enter] is not entered within this time during the booting
process, the APPL.-Login is called.
ACS-2 plus booting: Either interrupt the power supply for a
short period of time (pull the
power connector, deactivate the
emergency power supply, if
necessary),
To Next Page
Loading...
