Installation instructions / ACS-2 plus 47
or press the Reset button.
Normally, the APPL.-Login is sufficient.
Advantages: The normal course of operations is not disturbed.
Login must not be carried out within the above
mentioned 3 seconds during the booting process.
Certain DIP switch settings have priority and do not permit any
modifications in the Communication - To Host area (see section
Dependencies in this chapter). This error is signaled by the
message "Defined by DIP switch".
All peripheral devices connected to this ACS-2 plus
are out of operation (the doors are closed) during
BOOT-Login until the ACS-2 plus setup is left
again.
Label: shows the designation of the current ACS-2 plus.
Example: [<no-name...>] = no name was given.
If the controller already exists in NetEdit, the designation given there
is shown under Label.
Important: Use only unique designations!
The individual menu items:
General: The last line is the dialogue line. Here, different entries are allowed depending on the
cursor position. Use either small or capital letters. When entering a character which
is not allowed at this point or when pressing the Enter key only, no modification is
carried out. In this case, the program skips back to the next higher level (max. the
main menu).
False entries can be erased by character with the backspace key.
To delete the character buffer press the backspace key at least 3 times.
1. Communication:
Currently, there is only selection 1. To Host. Here, the parameters used by the ACS-2
plus for the communication with the host can be checked and set. The currently set
protocol is marked with "=>". The other current values are shown in the Status line.
To Next Page
Loading...
