TouchCenter Installation and Setup Guide
2–4
2. Connect ground to the TouchCenter using step a or b below.
a. If powering the keypad from the control panel, connect the
AUX – terminal of the control panel to the – terminal block
position (GND terminal of the TouchCenter (black wire)).
b. If powering the keypad from a supplementary power supply,
connect the AUX – terminal of the control panel to the (–)
terminal of the supplementary power supply (black wire).
Then, connect the (–) terminal of the supplementary power
supply to the – terminal block position (GND terminal of the
TouchCenter (black wire)).
3. Connect Data Out terminal of the control panel to the Y terminal
block position (Data In terminal of the TouchCenter (yellow
wire)).
4. Connect the Data In terminal of the control panel to the G
terminal block position (Data Out terminal of the TouchCenter
(green wire)).
5. Mount the TouchCenter onto the mounting plate as shown in
Figure 3.
TOUCHCENTER
WALL
MOUNTING
PLATE
TYPICAL
4
PLACES
6271CV-007-V0
Figure 3. Mounting the TouchCenter
To Next Page
Loading...
