TouchCenter Installation and Setup Guide
1–2
Compatibility
The below listing identifies the alarm systems that the TouchCenter
can interface with, the maximum number of TouchCenters that can
be used with each system, and the minimum alarm panel software
revision level for compatibility.
MAXIMUM NUMBER MINIMUM SOFTWARE
ALARM SYSTEM
OF TOUCHCENTERS REVISION LEVEL
VISTA-15P 2 3.0
VISTA-20P 2 3.0
VISTA-20P 4 5.0
VISTA-20PS 2 3.0
VISTA-20PS 4 5.0
VISTA-128BP 3 2.4
VISTA-128FBP 3 1.6
VISTA-250BP 3 2.4
VISTA-250FBP 1 1.5
VISTA-250FBP 3 2.0
• On all panels except the residential panels, you may obtain the
software revision level of the alarm panel by entering the program
mode and then entering #92 on the keypad. The second line of the
keypad displays the software revision level (without the decimal
point).
• The keypad sound suppression feature available in some commercial
panels is not compatible with the TouchCenter.
ECP Error
The message “ECP Error” will be displayed at the top of the screen (except for
the Home screen) when the
TouchCenter cannot communicate with the
alarm panel. This may be caused by an incorrect ECP address in the
TouchCenter or because AUI type devices have not been enabled in the
panel. While this message is being displayed, you must use the
TouchCenter default code of “4140” any time the TouchCenter requests an
authorized code.
To Next Page
Loading...
