Honeywell ADEMCO 6271 Series - How to View the Panel Configuration

SECTION 4: Initial Setup
4–11
SCREEN ACTION
2. Enter the 4-digit User Code
corresponding to the user that you want to
obtain Authority Level information about.
An Authority Level screen containing this
information will be displayed.
3. Press the BACK button to return to the
“Central Station Screen”.
Note: The User Levels listed on this
screen match the User Levels in
commercial panels. See the chart below
for corresponding User Levels in
Residential Panels.
Authority In Panel Level Shown As
Standard User Operator A
Arm Only Unknown
Guest Operator B
Duress Duress
Partition Master Master
System Master Master
How to View the Panel Configuration
The Panel Config button displays a screen that contains the
configuration of the panel that the TouchCenter is connected to. To
view the panel configuration, do the following:
SCREEN ACTION
1. On the “Central Station” screen press
the Panel Config button. A Panel
Configuration screen will be displayed
providing details of your system.