Honeywell ADEMCO 6271 Series - Troubleshooting; Panel Fault Displays

7–1
SECTION 7
Troubleshooting
•••••••••••••••••••• ••••••••• •••
In This Section
♦ Troubleshooting
♦ Panel Fault Displays
♦
Diagnostics
♦ Performing Diagnostics
•••••••••••••••••••• ••••••••• •••
Troubleshooting
For troubleshooting procedures, refer to the Control Panel
Installation Guide.
Panel Fault Displays
The “Arming” screen displays an Icon(s) if a panel fault(s) occurs. The
fault Icon is displayed to the left of the Panic button. The following
Icons may be shown as applicable to your system:
ICON MEANING
AC Loss – The system is not receiving AC power.
Bell Failure – The system bell or siren has a problem. Note: This
Icon will be displayed when interfacing with residential panels only.
Expander Failure – The system has a failure in an expansion
module.
Low Battery – The system battery, that powers the system during an
AC power loss, is low.
LRR Supervision Failure – The Long Range Radio used to commun-
icate with the central station has a supervision failure. Note: This
Icon will be displayed when interfacing with residential panels only.
Pager Failure – The system cannot communicate with an assigned
pager.
Phone Line 1 Failure – The system is not able to communicate with
the central monitoring station over the primary phone line.
Phone Line 2 Failure – The system is not able to communicate with
the central monitoring station over the secondary phone line.
Wireless Failure – The system is not able to communicate with its
wireless devices.