2–1
SECTION 2
Mounting and Wiring
•••••••••••••••••••• ••••••••• •••
In This Section
♦
Mounting the TouchCenter Mounting Plate
♦
Wiring the TouchCenter
•••••••••••••••••••• ••••••••• •••
Mounting the TouchCenter Mounting Plate
The TouchCenter should be mounted using the following criteria:
• The TouchCenter must be mounted indoors
• should be mounted at eye level for easy viewing by the user
• should not be mounted in areas of high condensation such as
bathrooms
• should not be mounted in locations where bright light or sunlight
shines directly on the screen
To mount the TouchCenter mounting plate, complete the following
steps:
1. Detach the mounting plate from the TouchCenter by pushing it
toward the bottom of the TouchCenter.
2. Locate the mounting plate over the mounting surface such that
the opening in the mounting plate is aligned with the wire/cable
access opening (in the mounting surface) while passing the
wires/cable through the opening in the mounting plate. (See
Figure 1.)
Note: The back of the TouchCenter has wire channels leading to
the bottom and the left side if surface wiring is being used.
3. Secure the mounting plate to the mounting surface using four
screws (supplied).
To Next Page
Loading...
