SECTION 4: Initial Setup
4–5
SCREEN ACTION
5. Enter your 4-digit Installer code. The
“Advanced Setup” menu screen is
displayed.
Note: If the top of the screen is displaying
ECP Error, the ECP address in the
TouchCenter is not valid for the panel that
it is connected to. To change the ECP
address in the TouchCenter when ECP
Error is being displayed, enter the
TouchCenter default code of “4140” to
advance to the next screen.
6. Press the Central Station button. The
“Central Station” menu screen is
displayed.
NOTE: The Resets and Running counters
are shown on this screen near the lower-
left corner. The Resets counter displays
the number of times the TouchCenter has
been reset since it was installed while the
Running counter indicates how long the
TouchCenter has been running since the
last time it was reset.
To Next Page
Loading...
