AreaRAE Plus & AreaRAE Pro User’s Guide
33
11 Turning The AreaRAE Plus/Pro On And Off
11.1 Turning The AreaRAE Plus/Pro On
With the instrument turned off, press and hold the [MODE] key until the beep sounds and the display and
LED alarm lights turn on. Then release the [MODE] key.
A RAE Systems logo (or a company name) should appear first. This is followed by a progression of
screens that tell you the AreaRAE Plus/Pro’s current settings.
11.1.1 Pausing To View Screens During Startup
Press the [MODE] button anytime during the startup sequence to pause the progression. This allows you
to view the information for as long as you like. To resume the progression, press [MODE] again. Even if
you pause the progression of screens, the startup process is not interrupted.
Note: To speed up the startup time, the number of screens shown on startup can be reduced by enabling
the Fast Startup option under Programming/Monitor.
Then the AreaRAE Plus/Pro’s main reading screen appears. It displays instantaneous readings similar to
the following screen (depending on the sensors installed) and is ready for use.
Note: If the battery is completely empty, then the display briefly shows the message “Battery Low,” and
the AreaRAE Plus/Pro shuts off. You should charge the battery or replace it with a fully charged battery
before turning it on again.
11.2 Turning The AreaRAE Plus/Pro Off
Press and hold [MODE]. A 5-second countdown to shutoff begins. You must hold your finger on the key
for the entire shutoff process until the AreaRAE Plus/Pro is powered off.
To Next Page
Loading...
