Honeywell AreaRAE Plus - 12 Programming; Enter Programming in Basic Mode

AreaRAE Plus & AreaRAE Pro User’s Guide
36
12 Programming
The menu in Programming Mode is to adjust settings, and calibrate sensors. It has the following
submenus:
 Measurement
 Alarms
 Datalog
 Wireless
 Monitor
 Calibration
12.1 Enter Programming In Basic Mode
Programming in Basic Mode is limited to calibration only. A password is required to access other
programming menus.
1. To enter Programming Mode, press and hold [MODE] and [N/-] until you see the Password screen.
2. Input the 4-digit password:
 Increase the number from 0 through 9 by pressing [Y/+].
 Step from digit to digit using [N/-].
 Press [MODE] when you are done.
If you make a mistake, you can cycle through the digits by pressing [N/-] and then using [Y/+] to change
the number in each position.
Note: The default password is 0000.
Note: The password screen appears when you enter the Programming Mode the first time after turning the
instrument on in Basic Mode, and each time after that.