With IR and LEL sensor installed:
I M1 Ex da ia op is I Ma, -40°C≤ Tamb ≤ 60°C
II 1G Ex da ia op is IIC T4 Ga, -40°C≤ Tamb ≤ 60°C
Without IR and LEL sensor installed:
I M1 Ex ia I Ma, -40°C≤ Tamb ≤ 60°C
II 1G Ex ia IIC T4 Ga, -40°C≤ Tamb ≤ 60°C
Contains FCC ID: SU3RMBLED
Contains IC: 20969-RMBLED
CAN ICES-3(A)/NMB-3(A)
FCC Compliance statement
This Detector complies with part 15 of the FCC Rules. operation is subject to the following two
conditions: (1) This Detector may not cause harmful interference, and (2) this Detector must
accept any interference received, including interference that may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits for a Class A digital
Detector, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference when the equipment is operated in a commercial
environment. This equipment generates, uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the instruction manual, may cause harmful interference to
radio communications. Operation of this equipment in a residential area is likely to cause
harmful interference in which case the user will be required to correct the interference at his
own expense.
BW Flex Series 6 User Manual
To Next Page
Loading...
Need help?
General
