Honeywell BW Flex Series User Manual

CHAPTER
2
Operations
Learn what you can do with your Honeywell BW™ Flex Series Detector, from commissioning to
Calibration.
Out of the Box First Run
This operation is only executed the first time the detector is turned on.
1. Turn on the Detector. LEDs flash red, Sensors warm up, and the Detector performs the
following Self-Tests: Battery, Firmware, BLE, Sensors, and Bump and Calibration due date.
2. After completing the Self-Test, you are asked to set the detector up in four ways: Manually,
BLE, IR Link, and IntelliDoX.
3. Single-press the button to select a setup method.
4. Press and hold the button to initiate the selected method. For a detailed description of each
method, go to See "Set Language, Time, and Date" below for more information.
5. After the initial setup is complete, the IntelliFlash flashes green every fifteen seconds, and the
detector goes to the Regular mode. You are now ready to select any operation from the main
menu.
Note: We strongly recommend to review the Alarm Settings after Start-Up.
Set Language, Time, and Date
Configure the Language, time, and Date in a new detector on the first run setup.
There are four ways to set the Time Zone and Language in a new detector:
l Manual configuration via onscreen instructions.
l Via Device Configurator (DC) on a mobile device.
l Via Safety Suite Device Configurator (SSDC) on a computer.
l Via an IntelliDoX Docking Module. For further reference see the IntelliDoX User Manual.
Configure the Detector Manually
1. Turn on the Detector and wait until you see the "Setup Manually" screen.
2. On the "Setup Manually" screen, press and hold the button. The Language selection menu is
displayed.
You can select from the following languages:
English, Deutsch, Español, French, Italian, Portuguese, Russian, Nederlands, Simplified
Chinese, Traditional Chinese, and Korean.
BW Flex Series 9 User Manual

Honeywell BW Flex Series Specifications

General

Brand	Honeywell
Model	BW Flex Series
Category	Gas Detectors
Language	English