Honeywell BW RigRat - Wireless Communication; Mesh;LoRa and RF Network Configuration

CHAPTER
5
Mesh/LoRa Network Wireless Control
Mesh/LoRa Network Wireless Control and Submenus
When you step through the main menu, as shown in the Menus diagram, there is a screen for
wireless communication, containing information on wireless settings and status.
Note: Wireless settings are only present if the BW RigRat is equipped with a Mesh/LoRa Network
wireless module. Settings are managed through the Device Configurator app, under the
“Wireless” heading.
Settings include:
l
Mesh: Enable/Disable
l
Pan ID: 1 to 999
l
Channel: select
l
Interval: select
l
Off-Network Alarm: On/Off
l
Network Mode: Router/STD/Close Loop
l
RF: Enable/Disable
l
Pan ID: 1 to 999
l
Channel: select
l
Interval: select
l
Off-Network Alarm: On/Off
l
Network Mode: Router/STD
Wireless Mesh/RF Radio equipped models (that is, not Wi-Fi) allow you to check communication
with other wireless devices and get other useful information about the wireless settings.
BW RigRat 33 User Manual