CHAPTER
7
Battery Charging
Always fully charge the battery before using the BW RigRat. Its Li-ion batteries are charged by
connecting the instrument to its charger (P/N: W03-3044-000) and then plugging the charger
into an AC power source. In safe settings, use the AC Charge input with the included power
adapter.
Charging Ports
There are two charging ports:
l
AC Charging, Safe Area (left port)
l
Intrinsically Safe Charging For Hazardous Areas (right port)
Remove the cover for the appropriate port by turning it counterclockwise:
Note that the ports have different pin configurations and therefore require different cables for
connection.
IMPORTANT!
Make sure the cable connector is tight. Finger-tighten the connectors, but do not use tools.
Align the connector and plug and then press in and turn the ring until it clicks.
BW RigRat 48 User Manual
To Next Page
Loading...
