What to do if Honeywell Monitor shows 'Pump failed' message?
If your Honeywell Monitor displays a 'Pump failed' message or pump alarm, first, check for and remove any obstructions. Then, press the reset button to clear the alarm. If the problem persists, replace the contaminated water trap filter. Also, ensure that water condensation does not occur inside the unit. As a last resort, the pump itself may need to be replaced.
Why Honeywell RigRat LCD has no response when AC charger is connected?
If the Honeywell Monitor's LCD doesn't respond when the AC charger is connected, try using a different AC charger or reconnect the current one. Keep in mind that the unit might need some time to trickle charge the battery before it operates normally and displays messages on the LCD.
How to fix Honeywell Monitor buzzer and LED lights if they are inoperative?
If the buzzer and LED lights on your Honeywell Monitor are not working, check the LCD screen for a blinking “buzzer disabled” icon. You can also use the Device Configurator App to set both the Buzzer and Light to 'All On'.
What to do if Honeywell Monitor shows 'Lamp' message when power on?
If your Honeywell Monitor displays a “Lamp” message or lamp alarm when you power it on, try turning the unit off and then back on. If the issue continues, you may need to replace the UV lamp.
What to do if Honeywell Measuring Instruments show a 'Pump failed' message?
If your Honeywell Measuring Instruments display a 'Pump failed' message, it indicates a pump alarm. This can be due to several reasons: a blocked inlet probe, direct connection to a gas outlet with the gas valve off, water in the external filter, a dirty external filter, water condensation along the inlet probe, or a faulty pump or pump circuit. Try removing any blocking objects and then press the reset button to clear the pump alarm.
How to fix Honeywell BW RigRat when unable to connect to Device Configurator?
If you're having trouble connecting your Honeywell Measuring Instruments to the Device Configurator, it could be due to a Bluetooth issue, such as a password error or an outdated version of the Device Configurator. First, update your Device Configurator software. Also, try deleting the Bluetooth connection from your phone's settings and re-establishing the link with the instrument.
Why are the buzzer and LED lights not working on my Honeywell BW RigRat?
If the buzzer and LED lights are inoperative on your Honeywell Measuring Instruments, it could be because the buzzer is disabled or there's a problem with the buzzer or LED light itself. Use the Device Configurator App to set the Buzzer and Light to 'All On'.
What does the 'Lamp' message mean on Honeywell Measuring Instruments?
A 'Lamp' message on your Honeywell Measuring Instruments indicates a lamp alarm. This is often due to low ion concentration inside the PID lamp, especially in cold environments when first powered on, or a defective PID lamp or circuit. Replace the UV lamp.
What to do if Honeywell BW RigRat LCD has no response when AC charger is connected?
General| Display | LCD |
|---|---|
| Warranty | 2 years |
| Target Gases | H2S, CO, O2, LEL |
| Detection Principle | Electrochemical (O2, CO, H2S), Catalytic (LEL) |
| Range | H2S: 0-100 ppm, CO: 0-500 ppm, O2: 0-30% vol, LEL: 0-100% LEL |
| Sensors | H2S, CO, O2, LEL |
| Ingress Protection | IP66 |
| Alarms | Visual, audible, and vibration alarms |
To Next Page
