Honeywell BW RigRat - Status Indicators

BW RigRat User’s Guide
67
17. Editing Features
Some features can be turned on or off or edited directly on the RigRat, some can only be accessed
through the Device Configurator app, and some can be accessed and changed through both. This
table shows where features can be accessed.
Feature
RigRat
Device Configurator
Bump Test

Gas Calibration


Pump Calibration

Sensor On/Off


Set Span

Set Sensor Units

Set LEL Calibration Gas

Set LEL Measurement Gas

Get LEL/PID CF value

Set PID Calibration Gas

Set PID Measurement Gas

Set Multi-Calibration Gas

Set Gas Alarm Limits

Get/Set bump test date and interval

Get/Set calibration test date and interval

Get/Set Alarm Mode

Set Inert Mode

Alarm Settings

Secure Beep

Set Intelli-Flash

Set Intelli-Flash interval

Set Reverse Intelli-Flash

Set Reverse Intelli-Flash Interval

Datalog Interval

Datalog Sensor Selection

Datalog Data Selection

Datalog Type

Datalog Action When Full

Datalog Automatic Interval

Set Date

Set Time

Backlight

Set Site ID

Set User ID

Zero At Start

Radio On/Off

Mesh Radio Network Type

Set PAN ID

Set Channel

Set Wireless Interval

Off Network Alarm

Get BLE MAC address

GPS On/Off

Wi-Fi On/Off

Set Access Point SSID

Set Access Point Password

DHCP Enable
