BW RigRat User’s Guide
60
14. RAEMet Sensor Installation (not intended to be used in
explosive atmospheres)
If your RigRat is equipped with a RAEMet meteorological sensor (P/N: W03-3045-000), it is typically
removed for storage and must be attached before using it.
1. If the RigRat is on, turn it off. (Never attach or remove the RAEMet sensor without first turning
off the instrument’s power.)
2. Attach the RAEMet to the instrument‘s handle using the two U-shaped bolts and the wingnuts.
Then attach the sensor to the bracket.
3. Remove the cover over the Serial receptacle.
4. Align the RAEMet’s connector plug with the RigRat’s receptacle using the indexing keys and
slots as a guide.
To Next Page
Loading...
