BW RigRat User’s Guide
55
13. Maintenance
The RigRat requires little maintenance, aside from replacing sensors and filters. Maintenance and
service shall only be performed by trained personnel and following the Honeywell guidelines provided
in Honeywell training programs.
IMPORTANT!
Honeywell cannot guarantee the IP rating of an instrument that has been opened and not reassembled
according to instructions.
Cleaning
Use water and a soft cloth to clean the RigRat. Do not use detergents or solvents. Do not submerge
the instrument underwater.
Antenna Installation
Attach the antenna by opening the compartment, aligning the antenna, and turning the base of the
antenna until it is snug. (Tighten by turning clockwise, and loosen by turning counterclockwise.)
A number is marked on the antenna body for easy identification:
** Depends on wireless modem (if installed).
IMPORTANT!
Make sure the antenna type is correct, or wireless communication distance will be reduced. Always
tighten the antenna completely. Failure to do so will result in reduced communication distance.
To Next Page
Loading...
