Honeywell BW RigRat - Connect to Controller

BW RigRat User’s Guide
25
4.1.2. Connect To Controller
 Set RigRat instruments’ mesh wireless Network Mode to STD or Router by using the Device
Configurator app.
 Set RigRat, Portable devices, Mesh Router, and Controller to have the same PAN ID/Channel.
 The network is now ready. RigRat instruments will show on the Controller display.
Note: A router can bypass data. STD cannot bypass data, and can only act as an end device.
Enabling Router will cause the RigRat to consume more energy and decrease overall runtime before
recharging is necessary.
Mesh 868/915MHz
Mesh 2.4GHz