Honeywell BW RigRat - 4 Mesh Wireless Control and Submenus; Mesh Wireless Network (if Supported); Closed-Loop Network

BW RigRat User’s Guide
24
4. Mesh Wireless Control And Submenus
When you step through the main menu, as shown in the Menus diagram, there is a screen for wireless
communication, containing information on wireless settings and status.
Note: Wireless settings are only present if the RigRat is equipped with a Mesh Network wireless
module. Settings are managed through the Device Configurator app, under the “Wireless” heading.
Settings include:
 Mesh: Enable/Disable
 Pan ID: 1 to 999
 Channel: select
 Interval: select
 Off-Network Alarm: On/Off
 Network Mode: Router/STD/Close Loop
Wireless Mesh Radio equipped models (that is, not Wi-Fi) allow you to check communication with
other wireless devices and get other useful information about the wireless settings.
Mesh Wireless Network (if supported)
4.1.1. Closed-Loop Network
 Use the Device Configurator app to set all RigRat instruments’ mesh wireless Network Mode
to Closed Loop.
 Set all RigRat instruments’ mesh wireless PAN ID/Channel so that they are all the same.
 The RigRat instruments can now connect to each other.
 The following are shown on the RigRat LCD:
o Mesh icon:
o Network status: Not in network or remote device is in alarm or in network
o At the Mesh Network Summary screen, you can find more other RigRat status
information.