CHAPTER
15
RAEMet Sensor Installation
Installation
Note: Not intended to be used in explosive atmospheres
If your BW RigRat is equipped with a RAEMet meteorological sensor (P/N: W03-3045-000), it is
typically removed for storage and must be attached before using it.
1. If the BW RigRat is on, turn it off. (Never attach or remove the RAEMet sensor without first
turning off the instrument’s power.)
2. Attach the RAEMet to the instrument‘s handle using the two U-shaped bolts and the
wingnuts. Then attach the sensor to the bracket.
BW RigRat 86 User Manual
To Next Page
Loading...
