Honeywell BW Solo - Intelliflash

Honeywell BW Solo User Manual
30
• Digits 0 to 9
• Upper-case characters A to Z
• A space
9.15. IntelliFlash
IntelliFlash verifies operation and compliance by flashing the green LED on the top of the instrument at
intervals you select. This indicator notifies you that the monitor has no fault conditions and that all
required maintenance, such as bump test and calibration, has been performed.
You can turn IntelliFlash on or off. You can also turn the “beep” on or off and set the flash interval as 10,
30, or 60 seconds.
The default setting for IntelliFlash is off. The default interval is 30 seconds.