Honeywell CIU 888 - Implementing the Required Changes in the Site Configuration

Updating CIU 888 Site configuration
Ensite Pro to CIU 888 Migration Manual Part No.: 4417593_Rev09
4 - 2 CIU 888
$*6
the CIU 888 (see FIGURE 4-1). See Chapter 1 for more information
about the CIU 888 Configuration System.
FIGURE 4-1 CIU 888: Service port
 During updating of the CIU 888 site configuration, the Entis Pro
system connected to the CIU 888 must be shut down.
4.2 Implementing the required changes in the site configuration
The first step in updating the CIU 888 site configuration is implementing
the required changes in the site configuration.
Procedure:
1. Launch Ensite Pro, see section 1.2.1.
The Ensite Pro tool bar is displayed (see FIGURE 4-2).
FIGURE 4-2 Ensite Pro: Tool bar - Only Select Site button is active