4 Dolphin CT60 Mobile Computer
About the Battery
The computer uses a rechargeable 3.6 V Li-ion battery as its main power source.
The battery has a 14.6 watt hour capacity. Several factors determine the life of your
battery, such as display brightness, display timeout, input device, extreme
temperature, and your usage. Honeywell recommends that you keep the battery
charged at all times to prevent data loss.
Dolphin CT60 computers are designed for use with battery model CT50-BTSC
(p/n 318-055-001 and 318-055-005) manufactured for Honeywell International
Inc. Contact your local sales representative for replacement batteries.
Charge the Battery Before Use
Dolphin CT60 computers ship with the battery significantly discharged of power.
Fully charge the battery before using your computer for the first time.
You can charge the battery with a Dolphin CT50 series charging accessory before
or after you install the battery in the computer. A fully discharged battery charges
in approximately 6 hours.
To charge the battery before you install it in the computer:
• Insert the battery into the Honeywell Quad Battery Charger or the battery well of
a CT50 HomeBase or eHomeBase.
To charge the battery after installing it in the computer:
• Insert the computer into a CT50 HomeBase, eHomeBase, ChargeBase, NetBase,
USB Adapter, or Vehicle Power Adapter.
Note: Using the computer while charging the battery increases the time required to reach
a full charge.
Replace the Battery
If your battery power is low, you need to either charge the battery in the computer,
or replace it with a charged battery.
To replace the battery:
1. Save your files and close any open applications.
2. Press and hold the Power button until the options menu appears.
3. Tap Power Off and then OK to verify.
Caution: Read Battery Recommendations and Safety Precautions on page 9
and all cautionary markings on the battery, charging peripheral, and
device using the battery before attempting to install, use, or charge
the battery.
To Next Page
Loading...
