- 5 -
SPECIFICATIONS
Range: 16 m x 22 m
Power: 9.0 - 15 VDC; 9 mA typical, 14 mA maximum, 12 VDC;
AC Ripple: 3 V peak-to-peak at nominal 12 VDC
Alarm Relay: Energized Form A; 30 mA, 25 VDC, 22 Ohms
resistance maximum. Alarm Relay Duration: 3 seconds
Trouble Relay: Energized Form B; (NC) 30 mA, 25 VDC; 22 Ohms
resistance maximum
Tampers: Cover; (NC with cover installed) Form A;
30 mA, 25 VDC; Magnetic Field
Microwave Frequencies: DT8016MF4 - 10.525 GHz
DT8016MF5 - 10.587 GHz
RFI Immunity: 15 V/m, 80 MHz – 2.7 GHz
PIR White Light Immunity: 10,000 Lux typical
Fluorescent light filter: 50 Hz / 60 Hz.
Operating Temperature: -10° to 55° C
Relative Humidity: 5 to 95%; non-condensing
Temperature Compensation: Advanced Dual Slope
Dimensions: 11.6 cm H x 7.0 cm W x 4.3 cm D
Weight: 135 g / 5 oz (net weight)
ACCESSORIES
SMB-10
(P/N 0-000-110-01)
Swivel Mount Bracket
SMB-10C
(P/N 0-000-111-01)
Swivel Mount Ceiling Bracket
SMB-10T
(P/N 0-000-155-01)
Swivel Mount Bracket w/Tamper
Note : The accessories are not covered by certifications.
APPROVAL LISTINGS
Note: In EN 50131-2-4 compliant installations, mount the sensor at 2.3m,
enable look down, set the microwave sensitivity to maximum and lock
the sensor housing with the cover lock (see “[EN]” where noted in
Steps 1-4).
IMPORTANT: The sensor should be tested at least once each year.
NF&A2P 2 boucliers (référentiel NF324-H58) et
conforme aux normes EN50131-2-4 et
RTC50131-2-4; IP30 IK04
DT8016MF4 – N° de certificat: 2821420017
DT8016MF5 – N° de certificat: 2821420018
Organisme de certification:
CNPP Cert. : www.cnpp.com et
To Next Page
Loading...
