To Next PageTo Next PageWhat to do if Honeywell DUAL TEC DT8360ACM-SN Accessories sensor has self-test failure?
If your Honeywell Accessories sensor experiences a self-test failure, which includes microwave supervision failure, PIR self-test failure, or temperature compensation failure, try the following: * Cycle the power to the sensor. * Walk test the sensor. * If the trouble condition persists, replace the sensor.
What to do if Honeywell DUAL TEC DT8360ACM-SN Accessories sensor has low voltage?
If your Honeywell Accessories sensor is disabled due to low voltage, verify that the power supply provides sufficient voltage, ensuring it's at least 9V at the sensor.
How to fix Honeywell Accessories sensor if IR window is blocked?
If the Honeywell Accessories sensor's IR window is blocked or masked, verify that the sensor is not obstructed.
General| Brand | Honeywell |
|---|---|
| Model | DUAL TEC DT8360ACM-SN |
| Category | Accessories |
| Language | English |
Adjusts the PIR detection height by rotating the ring to point to the mounting height.
Activates walk test mode using a flashlight for 15 minutes after power up. Works with incandescent bulbs.
Sensor uses Active Infrared (AIR) technology to detect masking when objects are placed within 50mm of the sensor.
Remove masking materials or replace the sensor window to clear the anti-mask condition.
Equipment generates RF energy and may cause interference if not installed per instructions.
This Class B digital apparatus complies with Canadian ICES-003.
Device complies with FCC Rules Part 15 and Industry Canada license-exempt RSSs.
