Honeywell EBI XLS MASS NOTIFICATION SYSTEM - Ccs; Loc

HONEYWELL EMERGENCY NOTIFICATION MANAGER
39-00008-1
12
Table 3. ACU Programming Steps Table 4. LOC Programming Steps
LOC Programming Steps
XLS-DVC
6 Select FNA node in the All Call
list under General II tab
Fig. 16
* XLS3000 must be in network display mode to function as
part of an LOC.
DVC-RPU
1
Enable Paging Levels for which
All Call functionality is required.
Fig. 33
2
Program the DAL address -
critical to LOC operation
Fig. 34
LCD-160
1
Program RDP address - critical
to LOC operation.
page 25
CCS
A CCS is comprised of an XLS3000 and an XLS-DVC, or an
XLS-NCA2 and an XLS-DVC, or an EBI Workstation with
Desktop Microphone Kit.
Table 5. CCS Programming Steps
LOC
An LOC is comprised of an XLS-DVC in LOC mode, or a DVC-
RPU combined with an LCD-160. The LCD-160 must be
associated with an XLS3000 (in network display mode), or an
XLS-NCA2.
Table 4. LOC Programming Steps
LOC Programming Steps
XLS-DVC
Field Refer to
1
Set the MN mode, enable
paging levels.
Fig. 15
2
Enter associated XLS3000*/
XLS-NCA2 node number.
page 15
3
Program input categories and
priorities
Fig. 21
4
Create and program an MN
Active Tone
page 19
5
Create and program a Fire
Active Tone (when Fire is the
highest priority).
page 21
ACU Programming Steps
XLS3000*/XLS-NCA2
4 Program with MN type IDs. page 18
5
Program with MN Special
Function Zones.
page 19
* XLS3000 must be in network display mode to function as
part of an ACU.
XLS-DVC
1
Set the MN mode, enable
paging levels.
Fig. 15
2
Enter associated XLS3000/
XLS-NCA2 node number.
page 15
3
Program input categories and
priorities.
Fig. 21
4
Create and program an MN
Active Tone.
page 19
5
Create and program a Fire
Active Tone (when Fire is the
highest priority).
page 21
6
Select FNA node in the All Call
list under General II tab
Fig. 16
CCS Programming Steps
XLS3000*/XLS-NCA2
Field Refer to
1
Set the mass notification
priority.
page 15
2 Set the DCC field. page 13
3
Map to MN nodes. (Include the
FNA node in the map).
page 17
4 Program with MN type IDs. page 18
5
Program with MN Special
Function Zones
page 19
* XLS3000 must be in network display mode to function as
part of a CCS.
XLS-DVC
1
Set the MN mode, enable
paging levels.
Fig. 15
2
Enter associated XLS3000/
XLS-NCA2 node number.
page 15
3
Program input categories and
priorities.
Fig. 21