Honeywell Esser 2 Series - Test Mode

Extinguishing Control Computer 8010 - Series 2
FB 798352 / 11.07 73
12.7 Test mode
The automatic zones (1-8) can be switched to Test mode via the function keys and the ten-button keypad of the
control panel. For operation, the keypad must be enabled via the key switch.
Test operation
12345678
910111213
Detector zone
Fire/Switch off/Trouble
Un-
locked
K
e
y
b
o
a
r
d
R
e
l
e
a
s
e
6
Zone
In operation
Switching off
Test operation
Extra releasing 1
Outputs
Alarm
Emergency release
Extinguishing system
activated
Extinguishing system
enabled
In operation
Switching off
Test operation
Extra releasing 1
Outputs
Alarm
Emergency release
Extinguishing system
activated
Extinguishing system
enabled
In operation
Switching off
Test operation
Extra releasing 1
Outputs
Alarm
Emergency release
Extinguishing system
activated
Extinguishing system
enabled
Fig. 11: Operation example – Activating the Test mode, detector zone No.6
The zone input in Test mode is indicated in the zone display with a yellow/red flashing LED. The yellow LED
>Test Mode< also lights up to indicate that the zone display is showing the status of the detector zone.
Press the following key combination to activate and reset the detector zone:
On
Un-
locked
K
e
y
b
o
a
r
d
R
e
l
e
a
s
e
6
Zone
In operation
Switching off
Test operation
Extra releasing 1
Outputs
Alarm
Emergency release
Extinguishing system
activated
Extinguishing system
enabled
In operation
Switching off
Test operation
Extra releasing 1
Outputs
Alarm
Emergency release
Extinguishing system
activated
Extinguishing system
enabled
In operation
Switching off
Test operation
Extra releasing 1
Outputs
Alarm
Emergency release
Extinguishing system
activated
Extinguishing system
enabled
Fig. 12: Operating example – Deactivating Test mode, detector zone No.6