Galaxy Programming Manual
100
Option 56 – Communications
The Communications option is used to program the Galaxy Communication peripherals. This option has 4
sub menus, one for each of the communication peripherals. Each of these has its own set of sub menus as
detailed in the following pages.
1 = Telecoms
This section supports programming of the Telecom module, for alarm signalling and remote servicing over
PSTN.
2 = RS232
This section supports programming of the RS232 module to allow direct wire communication to a serial comm
port on a PC, or over PSTN using a third party modem connection.
3 = ISDN
This section supports programming of the ISDN module, for alarm signalling and remote servicing over ISDN
B and D channels.
4 = Ethernet
This section supports programming of the Ethernet module for alarm signalling and remote servicing over an
Ethernet LAN/WAN using both TCP/IP and UDP/IP protocols.
A list of the events controlled by each trigger is given in Appendix C of this Manual.
56 - Communications
To Next Page
Loading...
Need help?
General
