Communications [56] Galaxy Flex Installer Manual
126
On selecting the SIA format, you are prompted for the required SIA level. There are five
SIA levels available:
0 (default) – Basic event information with 4 digit account number.
1 – as level 0 plus 6 digit accounts.
2 – as level 1 but with event modifiers.
3 – as level 2 but with text descriptions.
4 – as level 3 but allows control commands to be received by the control panel.
SIA Trigger Events [56.1.01.2.level.1]
When you select the option, the first trigger event and its On/Off status is displayed (see
Table 10 for a list of available triggers). These are the events and alarms that are transmitted
to the ARC or computer. If the trigger status is set to On, an event activation results in
transmission of the event details to the receiver.
The table below shows the list of signalling triggers that are available to the Telecom
module, the USB module, the ISDN module and the Ethernet module.
No. Trigger Event No. Trigger Event
1 PA/Duress 12 Modules/Comms
2 Intruder 13 Elec Status
4 Security 14 Menu Access
5 Custom Zones 15 Trouble
6 Fire 16 Log Zone
7 Set Fault 17 Max Tag
8 Omit 18 Zone Restoral
9 Tamper 19 RF Supervision
10 Setting 20 Fault
11 Reset/Cancel
Table 10 Trigger Events
1=Status
To modify the trigger, select the required trigger type using A and B and press ent. To
program the status to On press 1, to set it to Off press 0. Press ent to save the programming
and return to the previous menu level.
Programming the SIA Format with Groups Enabled
If groups have been enabled on the system (refer to Options [63]) the SIA format option
alters, and an additional level is added.
1=Trigger Events
Press ent to display the first trigger event. The keypad shows the trigger, the trigger status
and the groups assigned.
1=Status As described above.
To Next Page
Loading...
