Galaxy Flex Installer Manual Install peripheral devices
15
Using the keypad:
1. Press any key. The following is displayed:
2. Select your language, and then press ent. The following is displayed:
3. Select the default set to load, and then press ent. There are country defaults from which
to choose.
4. Enter Engineer mode (for instructions see Engineer Mode on page 29). Any outstanding
faults or alarm conditions will be displayed if present. Press ent to accept these.
5. Set the time and date (41 ent).
6. If you are splitting your system into groups, enable groups now, before performing any
other programming (63 ent 1 ent 1 ent).
7. Select Auto Detect (72 ent).
In this mode the system automatically recognises any additional peripheral devices you
add to the system.
Install peripheral devices
1. Before applying power, select a valid and unique address on each device. The address
on most devices is set by either jumpers or a rotary switch.
Peripheral Valid addresses
FX100 FX050 FX020
Mk8 Keypad 0-7 03 03
Mk8 Keyprox 0-7 03 03
TouchCenter 0-2 02 02
RIO/PSU 2-12 2-6 2
DCM Reader 0-3 0-3 0-1
MAX 0-7 0-7 0-3
RF Portal 0-15 0-15 0-15
Defaults
1=UK
Language
1=English
To Next Page
Loading...
Need help?
General
