Honeywell Galaxy Flex - Alarm and Alert Management; Cancelling an Alarm; Restoring Alarms and Faults; Handling Alert Conditions

Galaxy Flex Installer Manual Install the power supply
13
Connect the power supply using one of the following options:
Plugged-in (option 1)
1. Connect the a.c. power cord to the sealed PSU, and secure the cord to the panel with a
cable tie.
2. DO NOT apply mains power.
Hard-wired (option 2)
1. Cut the a.c. power cord 15 cm from the figure-8 connector, and discard the part of the
cord with the mains plug.
2. Connect the remaining cord to the mains terminal block.
3. Connect the terminal block to a fused mains outlet, and secure the cable to the panel
with a cable tie.
4. DO NOT apply mains power.